TM 10-4930-236-13&Pi.Remove cotter pin (21), clevis pin (22) and link (23).j.Remove yoke (24), setscrew (25) and poppet (26) from the guide (27).k.Using drift on solid end of pin (28), remove pin and cam lock handles (29) from body (30).REPAIRWARNINGDry cleaning solvent, P-D-680, used to clean parts is potentiallydangerous to personnel and property. Avoid repeated andprolonged skin contact. Do not use near open flame orexcessive heat. Flash point of solvent is 100 degrees F-138degrees F (38 degrees C-59 degrees C).a.Clean all metal surfaces with dry cleaning solvent and dry thoroughly.b.Inspect all parts for damage or wear, and replace parts as required. Discard all mandatory replacement parts.ASSEMBLYWARNINGSilicone compound, MIL-S-8660, is toxic to skin, eyes andrespiratory tract. Skin and eye protection required. Good generalventilation is normally adequate.NOTEApply silicone compound to packings prior to installation.a.Position gasket (17) in body (30).b.Position cam lock handles (29) on body (30) and install pins (28). Use drift on open end of pins (28).c.Position yoke (24) in link (23) and install clevis pin (22) and cotter pin (21).d.Position poppet (26) in guide (27) and install setscrew (25). Install poppet and guide (26 and 27) on the yoke(24).Tighten setscrew (25).e.Install packing (20) and screw (19).f.Position assembled items in cylinder (14) and install spring (16), guide (15) and cylinder (14) in body (30). Installdust cap (13) to hold items in place.g.Install bushing (12) and flat washer (11).b.Install camshaft (10) through link (23), then install nylon bushing (9), nylon washer (8) and cotter pins (7).i.Turn the camshaft (7) so that its curve is toward open end of body (30).4-65
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
