TM 10-4930-236-13&P
CHAPTER 5
DIRECT SUPPORT MAINTENANCE INSTRUCTIONS
Page
Section I.
Repair Parts, Special Tools, TMDE, and Support Equipment ........................
5-1
Section II.
Troubleshooting ............................................................................................
5-1
Section III
Maintenance Procedures ...............................................................................
5-3
SECTION I. REPAIR PARTS, SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT.
5-1 GENERAL.
a.
For authorized common tools and equipment, refer to the Modified Table of Organization and Equipment
(MTOE) applicable to your unit.
b.
Test, Maintenance, and Diagnostic Equipment(TMDE) and support equipment include electrical test equipment,
standard pressure and vacuum gages, vacuum pumps, and charging manifolds found as standard equipment in any
direct support maintenance shop.
c.
Repair parts are listed and illustrated in the Repair Parts and Special Tools List, (RPSTL), AppendixF.covering
unit and direct support maintenance for this equipment.
SECTION II. TROUBLESHOOTING
5-2. GENERAL.
a.
Table 5-1 lists the common malfunctions which you may find during the operation ormaintenance of the tank and
pump unit. You should perform the tests/inspections and corrective actions in the order listed.
b.
This manual cannot list all malfunctions that may occur, nor all tests or inspections and corrective actions. If a
malfunction is not listed or is not corrected by listed corrective actions, notify your supervisor.
Table 5-1. Direct Support Maintenance Troubleshooting
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
WARNING
Disconnect intervehicle power cable from vehicle before
maintaining or replacing electrical components.
5-1
