TM 10-4930-204-13Figure 4-29.Ground Reel and Clips, Removal and Installation.(1) Clean parts with drycleaning solvent (item 1, App. F)and dry thoroughly.(2) Inspect(3) Replacec.Installation.for damaged or defective parts.damaged or defective ground reel as necessary.(1) Refer to figure 4-29.Install ground reel and securewith four bolts and four nuts.(2) Install two clips, two nuts, and two bolts.4-31.FUEL DISPENSING NOZZLE ASSEMBLY.a.Removal.Refer to figure 4-6 and remove nozzles and bondingwires.b.Cleaning andInspection.Drycleaning solvent normally has a flash pointof either 100 or 138 degrees F, depending on thetype being used, but may flash at much lower tem-peratures if contaminated with gasoline or jetfuel.Avoid repeated and prolonged skin contact.Do not use near open flame or excessive heat.4-56
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business