gage.b.InspectTM 10-4930-204-13(5) Remove two screws, washers, and differential pressure(6) Remove draincock and hose.(7) Remove pressure vent valve.Cleaning andInspection.Drycleaning solvent normally has a flash pointof either 100 or 138 degrees F, depending on thetype being used, but may flash at much lower tem-peratures if contaminated with gasoline or jetfuel.Avoid repeated and prolonged skin contact.Do not use near open flame or excessive heat.(1)(2)(3)float(4)(5)(6)(7)other areas.c.gage.(8)(9)Clean all parts in drycleaning solvent (item 1, App. F).Dry all parts thoroughly.Inspect sight gage for cracks, breaks, and transparency.ball for damage.Inspect gasket for breaks.Inspect differential pressure gage for signs of damage.Inspect draincock for free movement of draincock handle.InspectInspectReplaceInstallation.(1)(2)(3)(4)(5)InstallInstallInstallConnectInstalltubing for kinks, breaks, abraded areas andpressure vent valve and O-ring for damage.or repair defective parts.pressure vent valve (fig. 4-26).draincock and hose (fig. 4-27).differential pressure gage.flare nut couplings to differential pressuregasket, float ball and sight gage.4-53
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
