TM 10-4930-204-13b.Cleaning andInspection.Drycleaning solvent normally has a flash pointof either 100 or 138 degrees F, depending on thetype being used, but may flash at much lower tem-peratures if contaminated with gasoline or jetfuel.Avoid repeated and prolonged skin contact.Do not use near open flame or excessive heat.(1) Clean parts with drycleaning solvent (item 1, App. F),and dry thoroughly.(2) Inspect(3) Replacec.Installation.for any damaged or defective parts.parts as necessary.(1) Refer to figure 4-28; install manifold, and secure withthree nuts and bolts.(2) Install three-way valve lever and secure lever withsetscrew.(3) Reconnect hoses, as necessary.4-30.GROUND REEL ASSEMBLY.A ground reel is attached to the frame of the pumping assembly toprovide a means for electrically grounding the tank and pump unit.One section of the ground wire must be clipped to a ground connectionnear the tank and pump unit before the other section is connected tothe vehicle being fueled.a.Removal.(1) Refer to figure 4-29 and remove two nuts, two bolts,and two clips.(2) Remove four nuts and bolts and remove ground reel.b.Cleaning andInspection.Drycleaning solvent normally has a flash pointof either 100 or 138 degrees F, depending on thetype being used, but may flash at much lower tem-peratures if contaminated with gasoline or jetfuel.Avoid repeated and prolonged skin contact.Do not use near open flame or excessive heat.4-55
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
