TM 10-4630-207-13&P
0037 00
7. Ensure cables sit straight inside brake handle.
3
5
4
1
2
Figure 6. Reinstalling Brake Handle Assembly
To replace a main brake cable, proceed as follows:
1. Using long nose pliers, remove the cotter pin (figure 7, item 1) and retainer pin (figure 7, item 2) from
the brake handle assembly (figure 7, item 3).
2. Remove the rear hex nut (figure 7, item 4) and bolt (figure 7, item 5) from both brake handle
assemblies and bracket (figure 7, item 6).
3. Remove cable (figure 7, item 7) from the brake handle assembly (figure 7, item 3). Retain cable
bracket (figure 7, item 8).
5
2
4
7
8
6
1
3
Figure 7. Removing Main Brake Cable from Brake Handle Assembly
4. Locate parking brake cable clamp (figure 8, item 1) beneath trailer.
5. Loosen nuts (figure 8, item 2) on clamp and remove cable.
0037 00-5
