TM 10-4320-344-24
2.12 SOUND ENCLOSURE ASSEMBLY MAINTENANCE, MODEL 609-C.
2.12.1 Door Holder Assembly Replacement, Model 609-C.
This task covers:
2.12.1.1 Removal
2 .
12 . 1 . 2 I n s t a l l a t i on
INITIAL SETUP
Tools
Equipment Conditions
General Mechanic’s Automotive
Pumping station shut down, TM
Tool Kit, Appendix B, Section
10-4320-344-10.
111, Item 1
Material/Parts
General Safety Instructions
To prevent rolling or sliding, do not work
Lock Washers (TM 10-4320-344-24P)
on equipment that-is not securely
s t a b i l i z e d.
Do not work on equipment without following
standard shop safety precautions.
This procedure applies to all door holder assemblies.
Two different hook
configurations are used, two screw mounted and four screw mounted.
This
procedure covers the hook configuration secured by two mounting screws.
2.12.1.1 Removal.
a.
Remove
( 2 ) .
b .
Remove
c .
Remove
d .
Remove
two screws (Figure 2-11, 1) and lock washers (2).
Discard lock washers
hook (3) from enclosure (7).
four screws (4) and lock washers (5).
Discard lock washers (5).
holder (6) from enclosure (7).
2.12.1.2 Installation.
a .
Position hook (3) on enclosure (7).
b .
Install two new lock washers (2) and screws (l).
c .
Position holder (6) on enclosure (7).
d.
Install two new lock washers (5) and screws (4).
2-45
