a .
Remove four bolts (Figure 2-13,
1) and flat washers (2).
b .
Remove two door latch catches (3) from enclosure (4).
c.
Remove nine bolts (5).
d.
Remove door assembly (6) from enclosure (4).
2.12.3.2 Inspection.
a.
Inspect door assembly (6) for deterioration or damage of insulation material
on inner surface, corrosion, bends, or cracks.
b.
Inspect two door latches (8) and door assembly hinge (9) for damage.
c.
Inspect door assembly seal trim (7) for cracks or deterioration.
2.12.3.3 Repair.
a .
Replace damaged or deteriorated insulation material on inner surface of door
assembly (6).
Refer to Appendix D to manufacture new insulation material.
b .
Replace door assembly (6) if door latches (8) or hinge (9) are defective.
c.
Replace damaged door assembly seal trim (7).
2.12.3.4 Installation.
a .
Position door assembly (6) on enclosure (4).
b .
I n s t a l l n i n e b o l t s ( 5 ).
c.
Position two door latch catches (3) on enclosure (4).
d.
Install four flat washers (2) and bolts (1).
2-50
TM 10-4320-344-24
