SECTION V. UNIT MAINTENANCE PROCEDURES

9. ENGINE OVERHEATS. (Models 609-C and US636HCCD-1)

Figure 2-5. Data Plate Replacement. (Model 609-C Shown)

TM-10-4320-344-24 Pump Assembly Water 600 GPM Model 609-A (NSN 4320-01-184-7494) Model 609-C (NSN 4320-01-261-6470) Model US636HCCD-1 Manual
Page Navigation
48

TM 10-4320-344-24 SECTION V. UNIT MAINTENANCE PROCEDURES 2.11 GENERAL MAINTENANCE PROCEDURES. 2.11.1 Data Plate Replacement. This task covers: 2.11.1.1 Removal 2 . 11 . 1 . 2 I n s t a l l a t i o n INITIAL SETUP Use With Trailer-Mounted Pump Assemblies 609-A, 609-C and US636HCCD-1 Tools General Mechanic’s Automotive Tool Kit, Appendix B, Section III, Item 1 Riveter, Blind, Appendix B, Section III, Item 4 Material/Parts Rivets (TM 10-4320-344-24P) Equipment Conditions Pumping station shut down, TM 10-4320-344-10. General Safety Instructions To prevent rolling or sliding, do not work on equipment that is not securely s t a b i l i z e d . Do not work on equipment without following standard shop safety precautions. This procedure applies to all rivet mounted data plates on all pumping assemblies. The procedures for screw mounted and adhesive backed data plates are similar. 2.11.1.1 Removal. a . Remove four rivets (Figure 2-5, 1). b . Remove data plate (2). 2.11.1.2 Installation. a . Position data plate (2) on enclosure (3). b . Using blind riveter, install four rivets (1). 2-37 NOTE

Privacy Statement
Press Release
Contact