TM 10-4320-344-24f .Install two lifting eyes (4), flat washers (3), and nuts (2).Hand-tightenn u t s ( 2 ).Figure 3-41.Cylinder Head Assembly Bolt Tightening Pattern, Model 609-A.g .Tighten nuts in sequence shown in Figure 3-41.Torque nuts 1-4, 7-10, 13-16,and 19-20 to 75 ft-lbs (102 N•m),then to 125 ft-lbs (169 N•m), then to afinal 175 ft-lbs (237 N•m).Torque nuts 5-6,11-12, and 17-18 to 75 ft-lbs(102 N•m), then to 125 ft-lbs (169 N•m),then to a final 147 ft-lbs (199 N•m).h.Install 12 push-rods (1).i .Refer to paragraph 2.21.49 and perform cold valve adjustment.j .Refer to TM 10-4320-344-10 and start engine.Operate engine for one hour.The cylinder head nuts must be retorqued and the valves readjusted after 1hour operation.Failure to observe this caution could result in damage toequipment.k.Refer tol .Refer tom.Refer toTM 10-4320-344-10 and stop engine.step c above and torque cylinder head nuts.paragraph 2.21.49 and perform warm valve adjustment.3-93
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business