2.16.32 Governor Control Module Maintenance, Model 609-C

Figure 2-84. Location of Controlling Device, Model US636HCCD-1.

Figure 2-85. Governor Control Module Maintenance.

TM-10-4320-344-24 Pump Assembly Water 600 GPM Model 609-A (NSN 4320-01-184-7494) Model 609-C (NSN 4320-01-261-6470) Model US636HCCD-1 Manual
Page Navigation
223

TM 10-4320-344-24 2.16.32 Governor Control Module Maintenance, Model 609-C. This task covers: 2.16.32.1 Removal 2.16.32.3 Installation 2 . 1 6 .3 2 . 2 R e p a ir 2.16.32.4 Adjustment INITIAL SETUP Tools General Mechanic’s Automotive Tool Kit, Appendix B, Section III, Item 1 Material/Parts Lock Washers (TM 10-4320-344-24P Equipment Conditions Pumping station shut down, TM 10-4320- 344-10. Equipment Conditions (Continued) Battery disconnected, paragraph 2.15.3. General Safety Instructions Do not work on equipment that is not securely stabilized to prevent rolling or s l i d i n g. Do not work on equipment with battery connected. Electrocution hazard is present if battery is connected. Do not work on equipment without following standard shop safety precautions. 2.16.32.1 Removal. Do not work on equipment with battery connected. Electrocution hazard is present if battery is connected. Failure to obey this warning may result in serious personal injury. a. Open control panel door assembly (Figure 2-85, 1) and control panel (2). b. Disconnect electrical connector P6 (3) from governor control module (4). c . Remove four screws (5), lock washers (6), one cable clamp (7), and governor control module (4) from control panel assembly (8). Discard lock washers (6). 2.16.32.2 Repair. a . Inspect mounting hardware for damage. b . Replace all defective components. 2.16.32.3 Installation. a . Position governor control module (4) in control panel assembly (8) and secure with cable clamp (7), four new lock washers (6), and screws (5). b . Connect electrical connector P6 (3) to governor control module (4). 2-212

Privacy Statement
Press Release
Contact