TM 10-4320-344-24
2.16.32 Governor Control Module Maintenance, Unit 609-C. (Continued)
Figure 2-86. Governor Control Module Cover Removal.
Refer to figure 2-87 for location of named adjustment devices in the following
steps.
(1) Set the I adjustment at one division and the GAIN adjustment at the third
division from zero.
(2) Set the DROOP adjustment to the minimum setting.
(3) Set AUTO THROTTLE rheostat (Figure 2-86, 8) on control panel to mid range
and select SPEED on AUTO SELECT switch (9) on control panel.
(4) Refer to TM 10-4320-344-10 and start engine. Adjust SPEED potentiometer on
governor control module until engine is operating at approximately 1,575
rpm.
2-214
NOTE
