TM 10-4320-344-242.16.5 ControlPanelAssemblyRemovalandInstallation.ModelUS636HCCD-1.This task covers:2.16.5.1 Removal2 .16 . 5 . 2 I n s t a l l a t i o nINITIALSETUPToolsGeneral Mechanic’s AutomotiveTool Kit, Appendix B, SectionIII, Item 1Material/PartsTags, Appendix C, Item 31Lock Washers (TM 10-4320-344-24P)Equipment ConditionsEquipmentConditions(Continued)Battery disconnected, paragraph 2.15.4.Control Panel Cover Assembly removed,paragraph 2.16.2.General Safety InstructionsTo prevent rolling or sliding, do not workon equipment that is not securelys t a b i l i z e d .Pumping station shut down, TMDo not work on equipment with battery10-4320-344-10.connected.Electrocution hazard ispresent if battery is connected.Do not work on equipment without followingstandard shop safety precautions.2.16.5.1 Removal.a.b.c .d.e .f .g .h.Do not work on equipment with battery connected.present if battery is connected.Failure to obeydeath or seriousTag and remove( 2 ) .Tag and removeTag and removeTag and removegauge (8).personal injury.suction elbow hose (Figure 2-56,Electrocution hazard isthis warning may result in1) from suction gauge assemblydischarge elbow hose (3) from discharge gauge assembly (4).engine oil pressure gage hose (5) from oil pressure gauge (6).engine tachometer drive cable (7) from tachometer/hourmeterTag ten wires (9) from wiring harness (10) attached to terminal block (11).Loosen ten screws (12) and disconnect wires (9).Tag wire (13) attached to terminal 2 of controlling device (14).Loosen screw(15) and disconnect wire (13).Tag wire (16) attached to alternator light (17).Holding terminal connector(18), pull forward and disconnect wire (16).Pull wiring harness (10), hose assemblies (1,3 and 5), engine tachometerdrive cable (7), and wires (13 and 16) through control panel assembly mountingp l a t e ( 1 9 ) .2-151
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
