2.16.4 Control Panel Assembly Removal and Installation, Model 609-C.

Figure 2-55. Control Panel Assembly Removal and Installation, Model 609-C.

TM-10-4320-344-24 Pump Assembly Water 600 GPM Model 609-A (NSN 4320-01-184-7494) Model 609-C (NSN 4320-01-261-6470) Model US636HCCD-1 Manual
Page Navigation
159

TM 10-4320-344-24 2.16.4 Control Panel Assembly Removal and Installation, Model 609-C. This task covers: 2.16.4.1 Removal 2 . 16 . 4 . 2 I n s t a l l a t i o n INITIAL SETUP Tools Equipment Conditions (Continued) General Mechanic’s Automotive Battery disconnected, paragraph 2.15.3. Tool Kit, Appendix B, Section III, Item 1 General Safety Instructions Material/Parts To prevent rolling or sliding, do not work on equipment that is not securely Compound, Silicon Caulking, s t a b i l i z e d. Appendix C, Item 9 Rags, Appendix C, Item 20 Do not work on equipment with battery Tags, Appendix C, Item 31 connected. Electrocution hazard is present Lock Washers (TM 10-4320-344-24P) if battery is connected. Equipment Conditions Do not work on equipment without following standard shop safety precautions. Pumping station shut down, T M 10-4320-344-10. 2.16.4.1 Removal. Do not work on equipment with battery connected. present if battery is connected. Failure to obey death or serious personal injury. a . b. c . d . e. f . g . Open right side engine access door (Figure 2-57, Electrocution hazard is this warning may result in 1) on pumping assembly (2). Disconnect electrical connector J9 (3) and J10 (4) from bracket (5) behind control panel assembly (6). Open control panel assembly door (7) and control panel (8). Tag and disconnect flexible tube assemblies (9 and 10) from tee pipes (11 and 1 2 ). Remove silicon caulking compound from grommet (13) in rear of control panel assembly (6). Remove flexible tube assemblies (9 and 10) through grommet (13) in rear of control panel assembly (6). Remove six nuts (14), screws (15), lock washers (16), flat washers (17), and control panel assembly (6) from pumping assembly (2) . Discard lock washers (16). 2.16.4.2 Installation. a . Position control panel assembly (6) on pumping assembly (2) and secure with six flat washers (17), new lock washers (16), screws (15), and nuts (14). b. Insert flexible tube assemblies (9 and 10) through grommet (13) in rear of control panel assembly (6). 2-148

Privacy Statement
Press Release
Contact