2.16.6 Control Panel Assembly Hiring Maintenance, Models 609-C and US636HCCD-1.This task covers:2 .16 . 6 . 1 T e st2 .16 . 6 . 2 R e p a irINITIALSETUPToolsEquipment Conditions (Continued)General Mechanic’s AutomotiveBattery disconnected, paragraph 2.15.3 orTool Kit, Appendix B, Section2 .15 .4.III, Item 1Control Panel Assembly Cover removed,Multimeter, Appendix B, Sectionparagraph 2.16.2, (US636HCCD-1).III, Item 2General Safety InstructionsSoldering Gun, Appendix B,Section III, Item 2To prevent rolling or sliding, do not workon equipment that is not securelyMaterials/Partss t a b i l i z e d.Solder, Appendix C, Item 25Do not work on equipment with batteryStraps, Electrical Tiedown,connected.Electrocution hazard isAppendix C, Item 29present if battery is connected.Tags, Appendix C, Item 31Do not work on equipment without followingEquipment Conditionsstandard shop safety precautions.Pumping station shut down, TM10-4320-344-10.Do not work on equipment with battery connected.Electrocution hazard ispresent if battery is connected.Failure to obey this warning may result indeath or serious personal injury.2.16.6.1 Test.Using multimeter set for continuity, refer to Appendix F, asa p p l i c a b l e , and check continuity of wires.2.16.6.2 Repair.If any wire does not give continuity, refer to Appendix D and repairwiring harness as required.2-154TM 10-4320-344-24
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
