TM 10-4320-325-14
TO 34Y5-2-40-1
4.15.1. REPLACE/INSPECT DATA AND CAUTION INFORMATION PLATES.
This task covers:
a) Removal
b) Inspection
c) Installation
INITIAL SETUP
Tools
Materials/Parts
Tool Kit, General Mechanics
Lockwasher, MS35338-139
(Item 1, Appendix B, Section III)
Rivets, Blind, 1/8-inch, M24243/1-B404
Drill, Portable, -inch
(Item 2, Appendix B, Section III)
Equipment Condition
Drill Set, Twist
(Item 2, Appendix B, Section III)
None
Riveter, Blind, Hand
(Item 4, Appendix B, Section III)
REMOVAL: Refer to Figure 4-1.1.
WARNING
Wear safety goggles during blind rivet removal in order to protect
eyes from flying metal chips, or serious injury could result.
Notes
Perform step a to remove item identification data plate. Perform step
b to remove pump and engine oil drains identification data plate.
Perform step c to remove one of the two caution information plates
that are located on the pump frame opposite the pump and flywheel
cover.
a. Drill out four rivets (1) and remove data plate (2).
b. Drill out four rivets (3) and remove data plate (4).
c.
Remove two screws (5), washers (6), lockwashers (7), and nuts (8), and information plate (9).
Discard lockwashers.
INSPECTION:
Inspect plates (2, 4, or 9) for damage and illegibility. Replace as necessary.
INSTALLATION:
Note
Perform step a to install item identification plate. Perform step b to install
pump and engine oil drains identification plate. Perform step c to install
caution information plate.
Change 4
