TM 10-4320-307-24Section II. MAINTENANCE PROCEDURESINDEXParaParaAccessory Drive Assembly Repair/Replace ............................ ............................... 3-30Aftercooler Repair ...................... .......................... 3-24Alternator Repair .................................................. 3-21Cabinet Enclosure Repair/Replace ....................... 3-16Cam Follower Inspect/Repair/Replace .................. 3-34Casing and Cover Replace ................................... 3-10Cylinder Head AssemblyInspect/Replace ............................................... 3-36Engine Assembly Replace .................................... 3-20Engine Enclosure Repair ...................................... 3-5Fan Hub and Bracket Repair ................................ 3-25Flexible Coupling Inspect/Align/Repair/Replace ................................................ 3-7Flywheel and Flywheel HousingInspect/Replace/Align ................ ...................... 3-37Fuel Pump AssemblyService/Test/Replace ................. ..................... 3-29Fuel Tubing Repair/Replace ................................. 3-28Gear Cover Assembly Inspect/Repair .............. 3-39Governor Control Inspect/Test/Replace ................ 3-13HVT Valve AssemblyTest/Repair/Replace ........................................ 3-27Injectors Inspect/Replace ................ ..................... 3-35Lube Oil Cooler AssemblyInspect/Test/Repair ................... ...................... 3-32Lubricating Oil Pump AssemblyInspect/Replace ...............................................3-31Mechanical Seal and BearingAssembly Repair/Replace ............. ...................3-11Network Cable Repair ........................................... 3-17Oil Pan and Oil Gage BracketRepair/Replace ................................................ 3-38Overspeed SwitchInspect/Test/Replace ............... ........................ 3-14Piping and Vent Assembly Repair .........................3-9Pressure RegulatorInspect/Test/Replace ................. ......................3-15Pump Assembly Repair/Replace ......... .................3-8Pump, Shaft Assembly Inspection ........................3-12Radiator Assembly Repair ....................................3-19Rocker Lever Housing AssemblyRepair/Replace ................................................ 3-33Skid Repair/Replace ............................................. 3-40Speed IncreaserAdjust/Repair/Replace ................ .....................3-18Starter Motor Repair .................. ........................... 3-22Storage Box and Cover Repair .............................3-6Tank Assembly Repair .......................................... 3-4Water Pump Assembly Repair ..............................3-26Water Manifold Repair/Replace ............................3-233-3 GENERALINSTRUCTIONS.Most maintenance instructions in this section will list resources required, personnelrequired, and equipment condition for the start of the procedure. Note the following.a.Resources required are not listed unless they apply to the procedure.b.Personnel required are listed only if the task requires more than one. If PERSONNEL is not listed, it means oneperson can do the task.c.The normal standard equipment condition to start a maintenance task is engine stopped and START/STOPswitch set at STOP. EQUIPMENT CONDITION is not listed unless some other condition is required besides the powerbeing off.d.Refer to Appendix D to determine torque requirements when tightening threaded fasteners, unless a specifictorque value is given in the procedure. Standard torque values given in Appendix D are determined by thread size.e.If fuel tank has broken welds, dry it thoroughly before reworking cracked weld,;.3-4
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
