TM 10-4320-226-14
4.13.6 Suction Gauge (M4) and Discharge Gauge (M5) Replacement.
This task covers:
4.13.6.1 Removal
4.13.6.2 Installation
INITIAL SETUP
Tools
General Mechanic’s Tool Kit (appendix B,
Section III, Item 1)
Materials/Parts
Tags (appendix E, Section II, Item 12)
Equipment Conditions
Equipment shut down, refer to
paragraph 2.5.1.2 or 2.5.2.2.
Equipment Conditions (continued)
Control Panel Assembly Cover removed,
paragraph 4.13.1.
General Safety Instructions
To prevent rolling or sliding, do not
work on equipment that is not securely
stabilized.
Do not work on equipment without
following standard shop safety
precautions.
Figure 4-46.
Suction Gauge (M4) and Discharge Gauge (M5) Replacement.
4.13.6.1 Removal.
To prevent rolling or sliding, do not work on equipment that is not
securely stabilized.
Ensure both wheels are secure.
Failure to obey this
warning may result in serious personal injury.
a.
Tag and disconnect hose (figure 4-46, 1) from gauge (2).
b.
Remove three nuts (3), lockwashers (4), and screws (5) from gauge (2).
c.
Remove gauge (
4.13.6.2 Installation.
a.
Install gauge
b.
Install three
c.
If snubber is
2) from front of control panel.
(2) through
screws (5),
front of control panel.
lockwashers (4), and nuts (3) on gauge (2).
installed between hose and gauge, remove and discard snubber,
adapter, and elbow.
d.
Connect hoses (1) to gauge (2) and remove tags.
4-88
