TM 10-4320-226-14
4.13.10.1
Removal.
Refer to Figure 4-50 and proceed as follows:
To prevent rolling or sliding, do not work on equipment that is not securely stabilizes.
Ensure both wheels are chocked. Failure to obey these warnings may result in serious
injury.
a.
Remove nuts (l), washers (2), screws (3) and grommet (4).
b.
Disconnect panel light (5) from TB1-7 and remove panel light (5).
c.
Remove threaded spring plunger (6).
d.
Remove nuts (7), washers (8), screws (9) and spring plunger bracket (10).
4.13.10.2
Repair.
Refer to Figure 4-50 and proceed as follows:
a.
Remove lens cover (11).
b. Replace lamp (12).
c.
Install lens cover (11).
4.13.10.3
Installation.
Refer to Figure 4-50 and proceed as follows:
a.
Install spring plunger bracket (10), screws (9), washers (8) and nuts (7).
b.
Install threaded spring plunger (6).
c.
Route wire through opening in control panel and connect wire to TB1-7.
d.
Position panel light (5), secure with screws (3), washers (2) and nuts (1).
e. Install grommet (4).
Change 2 4-92.1