TM 5-4930-230-13NOTEAlternate nozzle for dispensing unleaded fuel is listed in Appendix D, AdditionalAuthorized List, Sec. II, Item 2.(f) Insert nozzles in vehicle or equipment fuel tanks carefully. Observe safe fueling rates stenciled near fueltanks.CAUTIONBe sure nozzle is operating correctly before starting electric motor.(g) Open the tank dispensing valve and place motor start switch in the ON position (figure 2-1).NOTEContinuous operation of the motor for more than 30 minutes will cause thethermo protector to activate. The motor will then shut off until it is cool.(h) Turn switch OFF when not dispensing fuel.NOTEOpening tank dispensing valve on full tanks should prime the pump. If not,manual priming can be done through the priming port (figures 1-4 and 1-5).(i) The float ball inside the water sight gage window located on the filter/separator should not be above theline mark on the window (figure 2-4).(j) Check the window frequently for the location of the float ball and drain the filter/separator when the ballreaches the line mark on the window.Figure 2-4. Sight Gage.Change 92-11
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
