CYLINDER HEAD AND BLOCK (CONT) - TM-5-4320-300-14

CYLINDER HEAD AND BLOCK (CONT) - TM-5-4320-300-14_371

5-19. SUCTION AND DISCHARGE GAGE VALVES, LINES, HOSES, AND FITTINGS

TM-5-4320-300-14 Pump Centrifugal Self-Priming Gasoline Engine Driven; 6-Inch 1500 GPM Capacity At 60 Foot Head Manual
Page Navigation
365

TM 5-4320-300-14 5-18. CYLINDER HEAD AND BLOCK (CONT) Location/Item Action Remarks 15. Exhaust mani- Clean gasket surfaces of exhaust manifold flange fold com- and companion flange. Position a new gasket on panion flange exhaust manifold flange. Align companion flange and pipe and pipe, and install on manifold flange. Tighten mounting nuts securely. 16. Exhaust Clean gasket surfaces. Position a new gasket on manifold exhaust manifold mounting studs. Position mani- fold on gasket and studs and hold against cylinder head. Install washers and mounting nuts on studs and tighten hand tight. Then torque nuts to 30 to 35 ft lb (41 to 47 N-m), beginning with nuts in center of manifold and working alternately toward each end. CAUTION Oil leaks may result if valve cover gasket is not positioned correctly, or if gasket becomes twisted during valve cover installation. 17. Valve cover Lightly coat new gasket with MIL-L-2104 oil and position on cyl- inder head. Install valve cover over gasket. Install special washers and mounting bolts. Tighten bolts securely. 5-76

Privacy Statement
Press Release
Contact