CYLINDER HEAD AND BLOCK (CONT) - TM-5-4320-300-14

CLEANING/ INSPECTION - TM-5-4320-300-14_369

TM-5-4320-300-14 Pump Centrifugal Self-Priming Gasoline Engine Driven; 6-Inch 1500 GPM Capacity At 60 Foot Head Manual
Page Navigation
361

TM 5-4320-300-14 5-18. CYLINDER HEAD AND BLOCK (CONT) Location/Item Action Remarks CAUTION When setting the cylinder head down on the valve side, support it on 2 inch (51 mm) thick wood blocks to protect cam followers and injector spray tips. Equipment damage could result if this procedure is not followed. 5. Cylinder head Set cylinder head on its placement side with exhaust mani- fold studs in an upright position. Then tip the head over and position it (with exhaust valves down) on wood blocks. 6. Cylinder head Remove from cylinder block and discard. oil seal ring, compression gaskets, oil seals, and water seals 5-72

Privacy Statement
Press Release
Contact