TM 5-4320-300-14
5-18. CYLINDER HEAD AND BLOCK (CONT)
Location/Item
Action
Remarks
11. Cylinder
Clean upper surface
block
with a clean cloth
dampened with VV-
F-800 diesel fuel and
dry with compressed
air. Visually inspect
for cracks, wear, and
signs of overheating.
Inspect piston crowns,
compression gasket
contact surfaces,
counterbores, seal
grooves, and bolt
holes for water, oil,
or foreign material.
Remove water, oil,
or foreign material;
replace block if it is
damaged.
INSTALLATION
12. Cylinder
Install new seals, gaskets, and oil seal ring on
Face colored
head oil
cylinder block.
stripe on oil
seal ring,
seal ring away
compression
from the cyl-
gaskets, oil
inder bores.
seals, and
water seals
5-74
