TM 5-3825-270-23&P
0163
ASSEMBLY - Continued
1
2, 3
12
11
10
9
4, 5
6
7
8
7
6
Figure 11. Water Turret Assembly.
17.
Loosely install lock handle (Figure 11, Item 8) with four washers (Figure 11, Items 6 and 7) on adjusting bracket
(Figure 11, Item 5) and bracket (Figure 11, Item 4).
18.
Install 84 ball bearings (Figure 11, Item 11) into two races (Figure 11, Item 3).
19.
Install two ball bearing plugs (Figure 11, Item 10) in two holes (Figure 11, Item 2).
20.
Install two retaining rings (Figure 11, Item 9) in holes (Figure 11, Item 2).
21.
Fill holes (Figure 11, Item 2) with sealant.
CAUTION
Do not over grease swivel joints. Excessive grease can cause leakage and/or difficult rotation.
Failure to comply may result in damage to equipment.
NOTE
Zerk fittings are required to be greased a total of three times.
22.
Lubricate two zerk fittings (Figure 12, Item 26) with small amount of grease.