TM 5-3825-270-23&P
0163
ASSEMBLY - Continued
18
19, 20
12
17
16
21
22
23
15
Figure 9. Water Turret Assembly.
2.
Install pressure seal (Figure 9, Item 7) in lower water turret tube (Figure 9, Item 12).
3.
Apply light coat of grease to dust seal (Figure 9, Item 16).
4.
Install dust seal (Figure 9, Item 16) in lower water turret tube (Figure 9, Item 12).
5.
Install fitting (Figure 9, Item 15) in lower water turret tube (Figure 9, Item 12).
6.
Install 84 ball bearings (Figure 9 Item 21) into two races (Figure 9, Item 20).
7.
Tighten lock knob (Figure 9, Item 18).
8.
Install two ball bearing retainer plugs (Figure 9, Item 22) in holes (Figure 9, Item 19).
WARNING
Wear proper eye protection and use care when removing and installing retaining rings.
Retaining rings are under spring tension and can act as projectiles when released. Failure to
comply may result in injury or death to personnel.
9.
Install two retaining rings (Figure 9, Item 23) into holes (Figure 9, Item 19).
WARNING
On direct contact, uncured silicone sealant irritates eyes. Wear proper eye protection and
gloves. If silicone sealant gets in your eyes, flush eyes with water and seek immediate medical
attention. In case of skin contact, wipe off skin and flush with water. Failure to comply may
result in injury or death to personnel.
