TM 5-3825-270-23&P
0145
INSTALLATION - Continued
26
27
14
6
3
11
15
18 10
2
7
GEARCASE
END
9
1
8
16
17
5
4
12
13
31
30
28, 29
Figure 16. Cylinder Head Gasket Installation.
4.
Install 18 screws (Figure 16, Item 31) in cylinder head (Figure 16, Item 28). Hand tighten screws.
5.
Torque 18 screws (Figure 16, Item 31) in sequence shown to 25 lb-ft (33.9 Nm).
6.
Torque 18 screws (Figure 16, Item 31) in sequence shown to 50 lb-ft (67.8 Nm).
7.
Torque 18 screws (Figure 16, Item 31) in sequence shown to 72.4 to 79.5 lb-ft (98.1 to 107 Nm).
WARNING
Prolonged contact with lubricating oil may cause skin rash. Immediately wash skin and
clothing thoroughly and remove saturated clothing that comes in contact with lubricating oil.
Keep area well-ventilated to keep fumes at a minimum. Failure to comply may result in injury
or death to personnel.
8.
Coat push rods (Figure 16, Item 30) with engine lubricating oil.
CAUTION
Install pushrods as noted prior to removal. Failure to comply may result in damage to
equipment.
9.
Install push rods (Figure 16, Item 30) on lifters (Figure 16, Item 29) and in cylinder head (Figure 16, Item 28).
10.
Install rocker arm assembly (Figure 16, Item 26) on cylinder head (Figure 16, Item 28) and push rods (Figure
16, Item 30) with four screws (Figure 16, Item 31). Torque screws (Figure 16, Item 27) to 37 to 41 lb-ft (49 to
55 Nm).
11.
Install cord (Figure 17, Item 25) and blue wire (Figure 17, Item 23) on glow plugs (Figure 17, Item 24) with four
washers (Figure 17, Item 22) and nuts (Figure 17, Item 21).
