TM 5-3825-270-23&P
FIELD MAINTENANCE
REAR ENCLOSURE PANEL AND SIDE RAIL REPLACEMENT
INITIAL SETUP:
References
Tools and Special Tools
Parts Manual (WP 0220) Figure 4023
Tool Kit, General Mechanic's: Automotive
(WP 0225, Table 1, Item 12)
Equipment Condition
Radiator and bracket removed. (WP 0076)
Materials/Parts
Glow plug relay removed. (WP 0131)
Foam Gasket (WP 0226, Table 1, Item 71) Qty: 1
Starter relay removed. (WP 0138)
Lockwasher (WP 0226, Table 1, Item 61) Qty: 1
Governor control module removed. (WP 0092)
Lockwasher (WP 0226, Table 1, Item 55) Qty: 4
Data plate removed. (WP 0157)
Isolator Mount (WP 0226, Table 1, Item 69) Qty: 4
Personnel Required
Construction Equipment Repairer 91L (2)
REMOVAL
NOTE
Remove cushion clips as required.
1.
Remove nut (Figure 1, Item 1), lockwasher (Figure 1, Item 2), and wire eyelet (Figure 1, Item 3) from rear
enclosure panel (Figure 1, Item 4). Discard lockwasher.
1, 2, 3
4
Figure 1. Rear Enclosure Panel And Side Panel Removal.
NOTE
Plate supports are not interchangeable. Tag and mark plate supports prior to removal to
ensure proper installation.
2.
Remove six screws (Figure 2, Item 5), plate support (Figure 2, Item 7), plate support (Figure 2, Item 8) and
rear enclosure panel (Figure 2, Item 4) from two side rails (Figure 2, Item 6).