//////////////////////////////////////////////////////////////////////////////////////////////////////////////
TM 5-3820-276-10-1
OPERATOR MAINTENANCE
EMERGENCY SHUTDOWN PROCEDURES - WELDER/GENERATOR
INITIAL SETUP:
Equipment Condition
Engine on (WP 0045)
EMERGENCY SHUTDOWN OF THE WELDER/GENERATOR
WARNING
The Water Well Drilling System presents numerous falling hazards. Use care when
working on top of equipment. Failure to comply may result in injury or death to personnel.
Seek medical attention in the event of an injury.
NOTE
The welder/generator has no emergency stop switch. The engine control switch or fuel
shutoff lever may be used to shut down engine in case of emergency.
1.
Rotate engine control switch (Figure 1, Item 1) to OFF position. If engine fails to shut down, proceed to
Step 2.
1
WWDS01054
Figure 1.
Engine Control Switch.
2.
Remove access cover (Figure 2, Item 1) from welder/generator.
02/13/2013root(emergencywp)wpno(O20022)
/////////////////////////////////////////////////////////////////////////////////////////////////////////////