TM 10-5430-245-13&P
0017 00
INSTALLATION
NOTES
Clean all parts before assembling.
Assemble parts on a clean surface.
1. Place shackle (Figure 9, Item 3) over swivel plate lug (Figure 9, Item 4) aligning shackle eyelets with hole in swivel plate
lug (Figure 9, Item 4).
2. Note that one of the shackle eyelets is threaded and the other is not. Insert screw pin (Figure 9, Item 2) through the
shackle eyelet with no threads and then through swivel plate lug (Figure 9, Item 4) hole.
3. Thread screw pin (Figure 9, Item 2) into shackle (Figure 9, Item 3) all the way.
4. Insert new cotter pin (Figure 9, Item 1) into screw pin (Figure 9, Item 2). Bend ends of cotter pin (Figure 9, Item 1) to
secure screw pin (Figure 9, Item 2).
4
2
3
1
CAUTION
When assembling the drum, it is very important to align chalk marks
to prevent twisting cable assemblies. Failure to align chalk marks may
cause damage to drum.
5. Unfold and layout drum body (Figure 10, Item 8). Lubricate edge of closure plate (Figure 10, Item 7) with detergent and
insert closure plate (Figure 10, Item 7) into drum body (Figure 10, Item 8) by placing cable notch in closure plate on the
bottom of the drum body opening.
6. Align chalk marks on closure plate (Figure 10, Item 7) with chalk marks on drum body (Figure 10, Item 8).
7. Attach three cable assemblies (Figure 10, Item 6) to closure plate (Figure 10, Item 7).
8. Place closure ring (Figure 10, Item 5) onto closure plate (Figure 10, Item 7) and align chalk marks.
