TM 10-5430-245-13&P
0017 00
CLEANING
Bearing Plate, Swivel Plate, Closure Ring and Closure Plate
1. Use abrasive cloth to remove raised metal or blend in depressions. Smoothness of repaired surfaces should equal
undamaged areas of the same functional surface.
2. Remove corrosion with cleaning brush.
Cable Assemblies
1. Remove raised metal and blend in depressions on cable assembly ends using abrasive cloth. Smoothness of repaired
surfaces should equal undamaged areas of the same functional surface.
CHECK HERE FOR SNAPPED OR
CHECK HERE FOR
BROKEN WIRES
RAISED METAL
WRONG
CABLE WIRES PROTRUDING FROM
END OF CABLE ASSEMBLY
WIRES
RIGHT
CHECK HERE FOR
NO WIRES PROTRUDING FROM
RAISED METAL
END OF CABLE ASSEMBLY
2. Using a file, remove cable wires protruding from cable assembly ends. Cable wires shall be even with cable assembly
end.
WARNING
All drum parts must be cleaned with a mild, non-toxic detergent and assembled
on a clean surface. Remember that the drum will be used to store and dispense
drinking water. A dirty or contaminated drum could cause sickness or even
death to personnel drinking from it.
Drum
Clean all drum parts with a mild, non-toxic detergent and cleaning brush.
