TM 10-4630-207-13&P
0049 00
11. Install cylinder head
a. Wipe mating surfaces clean on engine block and cylinder head seating surfaces using a lint free
cloth.
b. Install the new head gasket (figure 12, item 1) with the stamp mark of the part number facing up
(figure 12, item 2). The gasket part number is located between the No. 2 and No. 3 cylinders on
the gasket.
c.
Install the cylinder head (figure 12, item 3) on the engine block.
d. Lubricate the cylinder head mounting bolts (figure 12, item 4) with oil.
e. Install the M12 bolts (figure 13, item 1 through 8) and M8 bolts (figure 13, item 9 through 12)
hand tight.
f.
Tighten the bolts in the sequence shown in figure 13 to the following torques: M12X1.5 8.5 to 9.5
kg-m (61-69 ft-lbs). M8X1.25 18-25 kg-m (61-69 ft-lbs).
g. Torque the bolts in the sequence in figure 13 an additional 60 (one flat of the bolt).
h. Install and tighten front (figure 12, item 5) and rear hangers (figure 12, item 6) from 1.9 to 2.9 kg-
m. (14 to 16 ft-lbs).
0049 00-12
