TM 10-4630-207-13&P
UNIT MAINTENANCE
WASTE WATER VACUUM TANK TRAILER
NSN 4630-01-513-8155
DRIVE BELT
INSPECT, REPLACE
INITIAL SETUP:
Tools
Personnel Required
Tool Kit, General Mechanic's, Automotive (WP
63B Light Vehicle Mechanic
Materials/Parts
Equipment Condition
Gloves, Work (WP 0089 00, Table 2, Item 5)
Engine shut off
Rags, Wiping (WP 0091 00, Item 28)
Emergency button pushed in
Ignition key removed
INSPECT
WARNING
Allow the vacuum pump to cool for approximately 30 minutes before
servicing. The vacuum pump is hot and presents a burn hazard. Coming in
contact with hot vacuum pump parts may cause burns and severe injury.
WARNING
The vacuum pump inside mounting bolts are located in a restricted space.
Exercise caution and wear gloves when loosening and tightening these bolts
to avoid injuries due to pinching.
WARNING
The drive belt guard is heavy. To avoid injury, two soldiers are required to
remove and install the guard from and onto the trailer.
1. To remove drive belt guard proceed as follows: remove hex bolts (figure 1, item 1) on the drive belt
guard brackets. Two are located at each end of the guard (figure 1, item 1), and one at the rear
center (figure 1, item 2). Retain hardware.
0029 00-1
