TM 10-4320-344-24
4.4.5.3 Repair.
•
Do not use cleaning solvent without proper ventilation and clothing.
Do not smoke or use near open flame or excessive heat.
Dry cleaning
solvent is potentially dangerous to personnel and property.
Clean
parts in a well-ventilated area.
Avoid inhalation of solvent fumes.
Wear goggles and rubber gloves to protect eyes and skin.
Wash
exposed skin thoroughly.
Failure to obey this warning may result in
personal injury or death.
•
To prevent the possibility of embedding foreign objects in the eyes,
safety glasses must be worn when using compressed air.
a .
Clean all components with cleaning solvent and thoroughly air dry all
components with compressed dry air.
b .
Inspect all components for damage.
c .
Replace all defective components.
4.4.5.4 Assembly.
a .
Install new gasket (18) in oil filler cap (17) and install oil filler cap (17)
on crankcase front cover (8).
b .
Install new shaft seal (16) in crankcase front cover (8).
c .
Install spring (15), with locating tang towards engine, cap (14), spacer (13),
and secure with plug (12).
d .
Install new gasket (11) and secure with oil cooler plug (10).
e .
Install sleeve bushing (9) in crankcase front cover (8).
4.4.5.5 Installation.
a .
Apply sealing compound to crankcase front cover (8).
b .
Position crankcase front cover (8) on engine.
c .
Install two spacers (7), new lock washers (6), and screws (5).
d .
Install two flat washers (4) and bolts (3).
e .
Install two flat washers (2) and bolts (1).
f .
Start engine, refer to TM 10-4320-344-10, and check for leaks.
4-23
