TM 10-4320-344-24
b .
Position governor assembly (11) on actuator bracket (12) and secure with four
socket-head screws (10), new lock washers (9), and nuts (8).
Ensure governor linkage is assembled to length measured during removal.
c .
Install bearing (6) on governor linkage rod and align bearing (6) with fuel
injection pump shut off lever (7) securing with screw (5), two flat washers
(4), and nut (3).
d .
Connect wiring harness (1) to governor control assembly (2).
e .
Refer to paragraph 3.8.6.4 and adjust governor.
3.8.6.4 Calibration and Adjustment.
Figure 3-21.
a .
Remove four screws
control box (4).
Governor Control Assembly Controls, Model 609-A.
(Figure 3-21, 1), washers (2), and cover (3) from governor
3-49