TM 10-4320-344-24
3.8.5 Magnetic Pickup Replacement.
This task covers:
3.8.5.1 Removal
3 .8 . 5 . 2 I n s t a l l a t i on
INITIAL SETUP
Tools
General Safety Instructions
General Mechanics Automotive
Tool Kit, Appendix B, Section
Do not work on equipment that is not
I I I,
Item 1
securely stabilized to prevent rolling
o r s l i d i n g.
Equipment Conditions
Do not work on equipment with battery
Pumping station shut down,
connected.
Electrocution hazard is pres-
TM 10-4320-344-10.
ent if battery is present.
Battery disconnected, paragraph
Do not work on equipment without
2.15.5 (609-A and US636HCCD-1) or
following standard shop safety practices.
paragraph 2.15.6 (609-C).
This procedure applies to Model 609-A.
The procedures for Models 609-C and
US636HCCD-1 are similar.
3.8.5.1 Removal.
Figure 3-19. Magnetic Pickup Unit Replacement.
a.
Disconnect wiring harness (Figure 3-19, 1).
b .
Loosen jam nut (2) and remove magnetic pickup unit (3) from engine (4).
3-45