3.8.7 Governor Actuator Assembly Maintenance, Model 609-C. (Continued)
c .
Replace all other defective components.
3.8.7.3 Installation.
a.
Position mounting bracket (13) on engine and secure with two new lock washers
(12) and cap screws (11).
b.
Position governor actuator assembly (8) on mounting bracket (13) and secure
with four nuts (10) and bolts (9).
c .
Connect cable connector (7) to actuator assembly (8).
Ensure length of governor linkage assembly meets measurement taken during
removal.
d.
Align bearing (5) with fuel injection pump lever (6) and secure with screw
(4), two flat washers (3), and new self-locking nut (2).
e .
Close right side engine access door (1).
f .
Refer to paragraph 2.16.32 and adjust governor control module.
TM 10-4320-344-24
NOTE
3 - 54