2.23.7.4 Assembly.

Figure 2-174. Brake Actuator Maintenance, Models 609-A and 609-C

2.23.8 Brake Actuator Maintenance. Model US636tlCC0-1.

TM-10-4320-344-24 Pump Assembly Water 600 GPM Model 609-A (NSN 4320-01-184-7494) Model 609-C (NSN 4320-01-261-6470) Model US636HCCD-1 Manual
Page Navigation
404

TM 10-4320-344-24 2.23.7.3 Repair. Do not use cleaning solvent without proper ventilation and clothing. Do not smoke or use near open flame or excessive heat. Dry cleaning solvent is potentially dangerous to personnel and property. Clean parts in a well- ventilated area. Avoid inhalation of solvent fumes. Wear goggles and rubber gloves to protect eyes and skin. Wash exposed skin thoroughly. Failure to obey this warning may result in personal injury or death. a . Clean all metal parts with rag dampened in cleaning solvent. b . Inspect shock absorber (3) for leaks and damage. c . Inspect all remaining components and mounting hardware for damage. d. Replace all defective components. 2.23.7.4 Assembly. a . Install pushrod washer (19), spring (18), and pushrod (17) into coupler assembly (13) and secure with new rivet (16). b . Insert shock absorber (3) into coupler assembly (13) and secure with screw (15) and nut (14). 2.23.7.5 Installation. a. b. c . d. e . Ensure pushrod fits into master cylinder when installing coupler assembly. Install coupler assembly (13) in brake actuator housing (4). Install chain (12) on breakaway lever (11). Insert breakaway lever (11) into coupler assembly (13) and secure with screw (10) and nut (9). Insert eight bushings (8), four coupler assembly mounting studs (7), four connecting links (6) over coupler assembly mounting studs (7), and secure with eight connecting link mounting nuts (5). Install screw (2) and nut (1) securing shock absorber (3) to rear of brake actuator housing (4). 2-393 NOTE

Privacy Statement
Press Release
Contact