TM 10-4320-344-242.23.8 BrakeActuatorMaintenance,ModelU56WCCD-1. (Continued)2.23.8.4 Assembly.a .Position lunette eye (28) against inner slide assembly (12) and secure withtwo bolts (27) and nuts (26).b .Insert two shock absorbers (25) in inner slide assembly (12) and secure withtwo shock absorber retaining pins (24) and new cotter pins (23).c .Install two top bearings (22), side bearings (21), and one pushrod block (20).d .I n s t a l l g r e a s e f i t t i n g ( 1 9 ) i n r o l l e r b o l t ( 1 6 ).2.23.8.5 Installation.a .b .c .d.e .f .g .Position front roller cover (18) and front roller (17) on outer case assembly(13) and secure with front roller bolt (16), new lock washer (15), and nut( 1 4 ).Slide inner slide assembly (12) into outer case assembly (13).Install lower master pin (10) through outer case assembly (13), inner slideassembly (12), and lower shock absorber (25) securing with flat washer (9) andnew cotter pin (8).Install upper master pin (10) through outer case assembly (13), inner slideassembly (12), two rear rollers (11), and upper shock absorber (25) securingwith flat washer (9) and new cotter pin (8).Install gasket (5) and chain (4) on breakaway brake lever (6).Install pushrod (7) and breakaway brake lever (6), into outer case assembly(13), and two brakeaway locks (3) securing with four new lock washers (2) andb o l t s ( 1 ) .Grease front roller (17).2-396
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
