2.23.10 HandbrakeAssemblyMaintenance.This task covers:2.23.10.1 Disassembly2.23.10.3 Assembly2 .23 .1 0 . 2 R e p a irINITIALSETUPToolsGeneral Mechanic’s AutomotiveTool Kit, Appendix B, SectionIII, Item 1Material/PartsCotter Pin (TM 10-4320-344-24P)Equipment ConditionsPumping station shut down, TM 10-4320-344-10.E q u i p m e n t C o n d i t i o n s ( C o n t i n u e d)Handbrake Cable disconnected from BrakeActuator, paragraph 2.23.9.General Safety InstructionsDo not work on equipment that is notsecurely stabilized to prevent rollingo r s l i d i n g.Do not work on equipment without follow-ing standard shop safety practices.This procedure applies to Model 609-A.The procedures for Models 609-C andUS636HCCD-1 are similar.2.23.10.1 Disassembly.Do not work on equipment that is not securely stabilized to prevent rollingo r s l i d i n g.Ensure remaining wheel of equipment has chocks that are secure.Failure to obey this warning may result in serious personal injury.a .Move handbrake actuator (Figure 2-177,1) up to release handbrake.b .Removec .Remove(4) .d .Removee.Removec o t t erf .Removehandbrake cable (2) from handbrake actuator (l).handbrake cable (2) and spring retention clip (3) from backing platescrew (5) and cable hanger clamp (6) from trailer chassis (7).cotter pin (8), flat washer (9), and cable retaining pin (10).Discardp i n ( 8 ).two mounting bolts (11), nuts (12), and handbrake lever assembly (13)from trailer chassis (7).g.Remove handbrake cable housing clamp (14) from handbrake lever assembly (13)and handbrake cable (2).2.23.10.2 Repair.a.Inspect handbrake cable (2) for damage and free movement of cable insheathing.b.Inspect allc .Replace all2-400components and mounting hardware for damage.defective components.TM 10-4320-344-24N O T E
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
