To prevent burns or other injuries allow oil filter and base assembly to coolbefore removing them.Failure to obey this warning may result in seriouspersonal injury.a.b.c .d.f .Place pan under oil filter (Figure 2-141, 1).Remove and discard oil filter (1).Remove two nuts (2), lock washers (3), screws (4), and fluid filter head (5)from angle bracket (6).Discard lock washers (3).Remove stud (7) from fluid filter head (5).Remove two screws (8), lock washers (9), angle bracket (6), and two mountingspacers (10).D i s c a r d l o c k w a s h e r s ( 9 ) . -2.21.26.2 Repair.a .Clean all fittings and components with clean cloth.To prevent the possibility of embedding foreign objects in the eyes, safetygoggles must be worn when using compressed air.b .Induce 25-35 psi (172.2-241.09 kPa) of air into lines to clear any foreignmatter.c .Inspect all components and mounting hardware for damage.d.Replace all defective components.2.21.26.3 Installation.a.Install angle bracket (6) and two mounting spacers (10) on intake manifoldflange and secure with two new lock washers (9) and screws (8).Torque screws(8) to 20 ft-lbs (27 N•m).b .Install stud (7) in fluid filter head (5).c .Position fluid filter head (5) on angle bracket (6) and secure with twoscrews (4), new lock washers (3), and nuts (2).d.Lightly coat gasket on new oil filter (1)f i l t e r ( 1 ) o n f l u i d f i l t e r h e a d ( 5 ).e.Refer to LO 10-4320-344-12 and add enginef .Refer to TM 10-4320-344-10, start engine,engine.with engine oil and install oilo i l .check for oil leaks, and stopg .Refer to LO 10-4320-344-12 check and add engine oil as required.h.Remove pan from under oil filter (1) and properly dispose of oil in accordancewith standing operating procedure.2-321TM 10-4320-344-24
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
