2.21.25 0i1 Bypass Line Rpair, Model US636HCCD-1.

Figure 2-139. Oil Drain Tube Assembly Replacemmt.

Figure 2-140. Oi1 Bypass Line Replacement, Model US636HCCD-1.

TM-10-4320-344-24 Pump Assembly Water 600 GPM Model 609-A (NSN 4320-01-184-7494) Model 609-C (NSN 4320-01-261-6470) Model US636HCCD-1 Manual
Page Navigation
329

TM 10-4320-344-24 2.21.25 0i1 Bypass Line Rpair, Model US636HCCD-1. This task covers: 2.21.25.1 Removal 2.21.25.3 Installation 2 . 2 1 .2 5 . 2 R e p a ir INITIAL SETUP Tools Equipment Conditions (Continued) General Mechanic’s Automotive Oil drained, LO 10-4320-344-12. Tool Kit, Appendix B, Section III, Item 1 General Safetv Instructions Material/Parts Do not work on equipment that is not securely stabilized to prevent rolling Rags, Appendix C, Item 20 o r s l i d i n g. Lock Washers (TM 10-4320-344-24P) Equipment Conditions Do not work on equipment without follow- ing standard shop safety practices. Pumping station shut down, TM 10-4320- 344-10. 2.21.25.1 Removal. To prevent burns or other injuries allow oil bypass line, oil cooler, and engine to cool before removing oil bypass line. Failure to obey this warning may result in serious personal injury. a. Unfasten, open and remove upper air cowling. b . Remove nut (Figure 2-140, 1), lock washer (2), bolt (3), pipe clamp halves (4 and 5), bolt (6), lock washer (7), and spacer (8). Discard lock washers (2 and 7). c . Loosen two retaining nuts (9) and remove oil bypass line (10). 2.21.25.2 Repair. a . Inspect all mounting hardware for damage. b . Replace all defective components. 2.21.25.3 Installation. a . Install oil bypass line (10) in engine (11) and secure with two retaining nuts ( 9 ). b . Install spacer (8) and two pipe clamp halves (4 and 5) and secure-with new lock washer (7), bolts (3 and 6), and new lock washer (2) and nut (1). c . Install upper air cowling. 2-318

Privacy Statement
Press Release
Contact