TM 10-4320-344-242.21.18 Starter Assembly Replacement.This task covers:2.21.18.1 Removal2 .21 .1 8 . 2 I n s t a l l a t i o nINITIALSETUPToolsGeneral Mechanic’s AutomotiveTool Kit, Appendix B, SectionIII, Item 1Materials/PartsTags, Appendix C, Item 31Lock Washers (TM 10-4320-303-24P)Equipment ConditionsPumping station shut down, TM 10-4320-344-10.Battery disconnected, paragraph2.15.2 (609-A), paragraph 2.15.3(609-C) and paragraph 2.15.4(US636HCCD-1).EquipmentConditions(Continued)Negative Power Cable Assembly disconnectedfrom starter, paragraph 2.15.6 (609-C).General Safety InstructionsDo not work on equipment that is notsecurely stabilized to prevent rollingo r s l i d i n g .Do not work on equipment with batteryconnected.Electrocution hazard is pre-sent if battery is connected.Do not work on equipment without follow-ing standard shop safety practices.This procedure applies to Model US636HCCD-1.The procedures for Models 609-Aand 609-C are similar.2.21.18.1 Removal.a .Remove two nuts (Figure 2-133, 1), lock washers (2), and tag and removebattery cable (3) and lead (4).Discard lock washers (2).b.Remove screw (5) and tag and remove lead (6).Do not let starter assembly fall when removing.Damage to equipment mayr e s u l t.c .Remove three bolts (7), lock washers (8),Discard lock washers (8).2.21.18.2 Installation.a .P o s i t i onbolts (7).b .Refer tot a g.c .Refer towashersstarter (9) on engine and securetag, install lead (6) and secureand starter (9) from engine.with three new lock washers (8) andwith screw (5).Remove and discardtags, install lead (4) and battery cable (3) securing with new lock2) and nuts (1).Remove and discard tags.2-303NOTE
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
