TM 10-4320-344-24SECTION I. REPAIR PARTS; SPECIAL TOOLS; TEST, MEASUREMENT, ANDDIAGNOSTIC EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT2.1 COMMON TOOLS AND EQUIPMENT.The General Mechanic’s Tool Kit, Appendix B, Section III, Item 1 is authorized. Forauthorized common tools and equipment, refer to Modified Table of Organization andEquipment (MTOE) applicable to you run it.2.2 SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT.Special tools, TMDE, and support equipment are listed in TM 10-4320-344-24P, RepairParts and Special Tools List (RPSTL) for the Pumping Assembly, Water, 600 GPMcovering unit, direct support, and general support maintenance, or the MaintenanceAllocation Chart (MAC), Appendix B of this manual.2.3 REPAIR PARTS.Repair parts are listed and illustrated in TM 10-4320-344-24P covering unit, directsupport, and general support maintenance of this equipment.SECTION II. SERVICE UPON RECEIPT2.4 SERVICE UPON RECEIPT.2.4.1 Siting and Location.For information on locating and positioning the pumpingassemblies refer to paragraph applicable TWDS technical manual.2.4.2 Unpacking.Instructions for unpacking the 600 GPM water pumping units areprovided below. A total of one task hour for Military Occupational Specialty (MOS)63J is required for unpacking each of the three pumping assemblies. Four total taskhours are required for unpacking each of the three pumping assemblies. Use carewhen removing the plywood box, braces, and two dust caps from the manifold toprevent damage to the equipment.2.4.2.1 Unpacking Models 609-A and US636HCCD-1.Additional tools will be required forunpacking Models 609-A and US636HCCD-1.The necessary tools will be available asTWDS Components of End Item (COEI), reference applicable TWDS technical manual. Forother applications, unpacking assistance must be provided by unit maintenancepersonnel. If depreservation is needed, depreservation assistance must also beprovided by unit maintenance personnel. Four personnel will be required to removethe plywood cap. Unpack Models 609-A and US636HCCD-1 as follows:a .If this is the initial use of the pumping assembly there should be a packinglist attached to the side of the plywood cap. There may also be a shortagepacking list and a depreservation guide attached to the plywood cap. Removeand save the document(s).Steel strapping used to secure plywood cap has sharp edges. To avoid personalinjury, use care when cutting and handling steel strapping.b .Using metal cutting shears, carefully cut metal strapping (Figure 2-1, 1) fromplywood cap (2). Remove metal strapping (1).c .Using four persons, one at each corner, lift plywood cap (2) from trailer (3).Save plywood cap for reuse when the pumping assembly is moved to anotherl o c a t i o n .2-2
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
