TM 10-4320-344-242.16.29 Cold Start Aid Cable Replacement, Model 609-C.This task covers:2.16.29.1 Removal2.16.29.2 InstallationINITIALSETUPToolsEquipmentConditions(Continued)General Mechanic’s AutomotiveBattery disconnected, paragraph 2.15.3.Tool Kit, Appendix B, Section III,Item 1GeneralSafetyInstructionsEquipment ConditionsDo not work on equipment without followingstandard shop safety precautions.Pumping station shut down, TM 10-4320-344-10.2.16.29.1 Removal.a.Open Cold Start Aid access door (Figure 2-80,1) on pumping assembly (2).b.Loosen screw on universal wire stop (3) and remove cold start aid cable (4)from actuator (5).c .Loosen wire nut stop (6) and remove cold start aid cable (4) from bottombracket (7).d.Remove screw (8), cable clamp (9), and pull cold start aid cable (4) outthrough grommet (10).e .Remove lock nut (11), handle (12), and cold start aid cable (4) from pumpingassembly (2).2.16.29.2 Installation.a.Install cold start aid cable (4) in pumping assembly (2).b.Install handle (12) on cold start aid cable (4) and secure with lock nut (11).c .Insert cold start aid cable (4) through grommet (10) and secure with cableclamp (9) and screw (8).d .Insert cold start aid cable (4) through wire nut stop (6), bracket (7), anduniversal wire stop (3) on actuator (5). Tighten universal wire stop (3).Ensure, when handle is pushed completely down, actuator is in fully down(released) positioned and when handle is pulled out actuator can be raised tomaximum open position.e.Loosen universal wire stop (3) and adjust cold start aid cable (4) as requiredto ensure proper operation.f .Tighten wire nut stop (6) and universal wire stop (3) and close Cold Start Aidaccess door (1) on pumping assembly (2).2-203NOTE
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
