TM 10-4320-344-24
2.16.28 Auto Defeat Cable Maintenance, Model 609-C.
This task covers:
2.16.28.1 Removal
2.16.28.3
Installation
2 .
1
6 .2 8 . 2 R e p a ir
INITIAL SETUP
Tools
General Mechanic’s Automotive
Tool Kit, Appendix B, Section III,
Item 1
Material/Parts
Lock Washers (TM 10-4320-344-24P)
Equipment Conditions
Pumping station shut down, TM 10-4320-
344-10.
Equipment Conditions (Continued)
Battery disconnected, paragraph 2.15.3.
General Safety Instructions
Do not work on equipment that is not
securely stabilized to prevent rolling or
s l i d i n g.
Do not work on equipment without following
standard shop safety precautions.
2.16.28.1 Removal.
a .
Open rightside engine access door (Figure 2-79,
1) on pumping assembly (2).
b .
Push handle (3) in and turn clockwise to LOCK position.
c .
Loosen screw (4) and remove universal wire stop (5) from end of auto defeat
cable (6) at governor actuator (7).
d.
Loosen nut (8) and pull auto defeat cable (6) away from cable bracket (10).
e.
Pull auto defeat cable (6) through stop plate (11) and remove two nuts (8) and
flat washers (9).
f .
Remove screws (12), cable clamps (13), nut (14), and lock washer (15) from
auto defeat cable (6).
g .
Using handle (3) pull auto defeat cable (6) out from pumping assembly (2).
h.
Remove two screws (16), lock washers (17), flat washers (18), and cable
bracket (10) from support (19).
Discard lock washers (17).
2.16.28.2 Repair.
a.
Inspect cable bracket (10) and mounting hardware for damage.
b.
Replace all defective components.
2.16.28.3 Installation.
a.
Position cable bracket (10) on support (19) and secure with two flat washers
(18), new lock washers (17), and screws (16).
If mounting hardware is mounted on auto defeat cable, remove all mounting
hardware.
b .
Feed auto defeat cable (6) through pumping assembly (2) and secure with lock
washer (15), nut (14), cable clamps (13), and screws (12).
2-201
NOTE
