2.16.25 ManualThrottleControlCableReplacement,Model609-A.This task covers:2.16.25.1 Removal2.16.25.2 InstallationINITIALSETUPToolsGeneral Mechanic’s AutomotiveT o o l K i t , A p p e n d i x B , S e c t i o n I I I,Item 1Material/PartsStraps, Electrical Tiedown, Appendix C,Item 29Equipment ConditionsPumping station shut down, TM 10-4320-344-10.Battery disconnected, paragraph 2.15.2.Power Control Cable Assembly removed,paragraph 2.15.8.EquipmentConditions(Continued)Control Panel Cover Assembly removed,paragraph 2.16.1.GeneralSafetyInstructionsTo prevent rolling or sliding, do not workon equipment that is not securelys t a b i l i z e d.Do not work on equipment with batteryconnected. Electrocution hazard ispresent if battery is connected.Do not work on equipment without followingstandard shop safety precautions.2.16.25.1 Removal.Do not work on equipment with battery connected. Electrocution hazard ispresent if battery is connected. Failure to obey this warning may result inserious personal injury.a.b.c .d.e.f .g .h.Turn manual throttle control knob assembly (Figure 2-76, 1) clockwise until iti s f u l l y i n.Unscrew cable sheathing connector (2) and unsnap manual throttle control cableconnector (3) from manual throttle control knob assembly ball (4).Remove backing nut (5), lock washer (6), and manual throttle control knobassembly (1).Remove nut (8) and lock washer (9) that secure pivot leg (10) to inboardthrottle arm (11) on fuel injection pump.Remove pivot leg (10), two lock washers (12), bracket (13), and nut (14) fromend of manual throttle control cable (15).Remove three cable clamps (16).Cut electrical tiedown straps (17) holding manual throttle control cable (15)to wiring harness (18).2.16.25.2 Installation.a .Insert manual throttle control cable (15) through grommet in rear panel (19).2-193TM 10-4320-344-24Pull manual throttle control cable (15) through grommet in rear panel (19).
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
