TM 10-4320-344-24
Figure 2-44.
Power Control Cable and Manual Throttle Control
c .
Install power control cable assembly (3) in cable connector
secure with new lock washer (8) and nut (7).
Cable Assembly.
bracket (9) and
d.
Adjust nut (11) so that knurled wire ends (16) are equal distance from cable
connector bracket (9).
Inboard throttle arm on fuel injection pump must be in vertical position (12
o’clock) when manual throttle control is turned at least one full turn but no
more than three full turns.
e .
Turn manual throttle control (Figure 2-45, 1) left until inboard throttle arm
(2) on fuel injection pump (3) is in vertical position (12 o’clock). If
required,
adjust power control cable assembly (4) and manual throttle control
cable (5) lengths to allow inboard throttle arm (2) to be in vertical position
(12 o’clock) within one to three turns of manual throttle control (1).
2-127
