2.15.7 Electrical Connector Receptacle Maintenance, Model 609-C.
This task covers:
2.15.7.1 Removal
2 .
15 . 7 . 3 I n s t a l l a t i o n
2 .
15 . 7 . 2 R e p a ir
INITIAL SETUP
Tools
General Mechanic’s Automotive
Tool Kit, Appendix B, Section
III, Item 1
Material/Parts
Tags, Appendix C, Item 31
Gasket (TM 10-4320-344-24P)
Lock Washers (TM 10-4320-344-24P)
Equipment Conditions
Pumping station shut down,
TM 10-4320-344-10.
General Safety Instructions
To prevent rolling or sliding, do not work
on equipment that is not securely
s t a b i l i z e d .
Disconnect negative battery cable at
negative battery to prevent possible
e l e c t r o c u t i o n.
Do not work on equipment without following
standard shop safety precautions.
2.15.7.1 Removal.
Do not work on electrical connector receptacle with negative battery cable
connected to battery terminal. Failure to obey this warning may result in
death or serious personal injury.
a.
Open left side engine access door (Figure 2-43, 1) on pumping assembly (2).
b .
Remove two screws (3) and lock washers (4).
Discard lock washers (4).
c .
Tag and remove negative power cable assemblies (5) and positive power cable
assemblies (6) from electrical connector receptacle (7).
d .
Remove four nuts (8), lock washers (9), screws (10) , and electrical connector
receptacle (7) from pumping assembly (2). Discard lock washers (9) .
e .
Remove insulator plate (11) and gasket (12). Discard gasket (12).
f .
Remove protective dust cap (13).
2.15.7.2 Repair.
a.
Inspect electrical connector receptacle (7), insulator plate (11), and
protective dust cover (13) for cracks, holes, deformations, and damage.
b .
Inspect mounting hardware for damage.
c .
Replace all defective components.
2.15.7.3 Installation.
a .
Install protective dust cover (13) on electrical connector receptacle (7).
b .
Position new gasket (12) and insulator plate (11) on electrical connector
receptacle (7) .
2-123
TM 10-4320-344-24
