TM 10-4320-344-242.15.6 Battery Cable Assembly and Power Cable Assembly Maintenance, Model 609-C. (Continued)a.b.c .d.e.f .Remove and discard electrical tiedown straps (Figure 2-42, 1).Tag and remove negative battery cable assembly (2) and positive battery cableassembly (3) from battery.Remove two screws (4) and cable clamps (5).Remove nut (6), bolt (7), and tag and remove two negative rower cablea s s e m b l i e s ( 8 ) f r o m t r a i l e r f r a m e a s s e m b l y ( 9 ) .Remove nut (10), lock washer (11), and tag and removeassembly (12) from starter (13).Discard lock washerRemove nut (14), lock washer (15), wire (16), and tagpower cable assembly (17) from starter (13). Discardnegative power cable(11) .and remove positivelock washer (15).2.15.6.2 Testing.Using multimeterr test continuity of negative battery cableassembly (2), positive battery cable assembly (3), negative power cable assemblies(8 and 12), and positive power cable assembly (17)If reading is greater than 1ohm, replace or repair defective cable assembly (2, 3, 8, 12, or 17) .2.15.6.3 Repair.a .Refer to Appendix D and repair battery cable assembly or power cable assembly.b .Replace all defective mounting hardware.2.15.6.4 Installation.a.Install positive power cable assembly (17) and wire (16) on starter (13) andsecure with new lock washer (15) and nut (14) .Remove and discard tags.b .Install negative power cable assembly (12) on starter (13) and secure with newlock washer (11) and nut (10). Remove and discard tags.c .Secure two negative power cable assemblies (8) to trailer framewith bolt (7) and nut (6). Remove and discard tags.d.Install two cable clamps (5) and secure with two screws (4).e .Secure positive battery cable assembly (3) and negative battery(2) with new electrical tiedown straps (1).assembly (9)cable assembly2-122
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
