2.15.8 Power Control Cable Assembly Maintenance, Model 609-A.

c . Install electrical connector receptacle

Figure 2-44. Power Control Cable and Manual Throttle Control Cable Assembly

TM-10-4320-344-24 Pump Assembly Water 600 GPM Model 609-A (NSN 4320-01-184-7494) Model 609-C (NSN 4320-01-261-6470) Model US636HCCD-1 Manual
Page Navigation
137

2.15.8 Power Control Cable Assembly Maintenance, Model 609-A. This task covers: 2.15.8.1 Removal 2.15.8.3 Adjustment 2 . 15 . 8 . 2 I n s t a l l a t i on INITIAL SETUP Tools General Mechanic’s Automotive Tool Kit, Appendix B, Section III, Item 1 Material/Parts Lock Washers (TM 10-4320-344-24P) Equipment Conditions Pumping station shut down, TM 10-4320-344-10. Equipment Conditions (Continued) Battery disconnected, paragraph 2.15.2. General Safety Instructions To prevent rolling or sliding, do not work on equipment that is not securely s t a b i l i z e d . Do not work on equipment with battery connected. Electrocution hazard is present if battery is connected. Do not work on equipment without following standard shop safety precautions. 2.15.8.1 Removal. a . b . c . d. e . Do not work on equipment with battery connected. present if battery is connected. Failure to obey death or serious personal injury. Loosen screw (Figure 2-44, 1) on universal wire wire stop (2) from power control cable assembly Loosen screw (4) and remove universal wire stop Electrocution hazard is this warning may result in stop (2) and remove universal ( 3 ) . (5) from wire (6). Remove nut (7) and lock washer (8) from end of power control cable assembly (3) and remove power control cable assembly (3) from cable connector bracket (9). Discard lock washers (8). Remove flat washer (10) and nut (11) from end of power control cable assembly (3). Remove three nuts (12), lock washers (13), three cable clamp mounting bolts (14), and three cable clamps (15). D i s c a r d l o c k w a s h e r s ( 1 3 ) . ^- 2.15.8.2 Installation. Do not tighten cable clamps securely until power control cable assembly has been adjusted. a. Install power control cable assembly with three cable clamp mounting bolts (12). b. Install nut (11) and flat washer (10) ( 3 ) . 3) in three cable clamps (15) and secure (14), new lock washers (13), and nuts on end of power control cable assembly 2-126 TM 10-4320-344-24

Privacy Statement
Press Release
Contact